Changing crank bearings and pulling an oiler gear

TK

Hand Rubbed Pork
Jan 9, 2012
8,808
8,483
113
Maine
www.tkpowerequipment.com
It's only a 137 Husky so I probably shouldn't be going through all this but it's for a guy that comes in all the time so I'll give him a break. He had a leaky seal on the mag side. The bearings on this clammy are rubber sealed so you gotta replace the bearings. It also has the pressed on oil gear that has to come off.





Just gotta remember where everything goez......

 

BloodOnTheIce

~Ice Gangsta~
Jan 10, 2012
2,043
2,087
113
Parts Unknown
It's only a 137 Husky so I probably shouldn't be going through all this but it's for a guy that comes in all the time so I'll give him a break. He had a leaky seal on the mag side. The bearings on this clammy are rubber sealed so you gotta replace the bearings. It also has the pressed on oil gear that has to come off.





Just gotta remember where everything goez......

You must really be bored...
 
Thread starter Similar threads Forum Replies Date
Jimmy in NC Husky 359 crank Wanted 8
Tor R Crank Mounting Tools - Ideas & Drawings Chainsawz 57
Barneyrb Crank Seals Chainsawz 13
M 3120xp questions - crank bearings and oil pump Chainsawz 11
SKEETER McCLUSKEY NOS 910 crank For Sale 3
rodburner04 Removing crank seals on a Jonsered 2171 Chainsawz 6
L stihl 038 cylinder and crankcase with crank For Sale 1
H stihl crank case corrosion Chainsawz 14
Chity_Avatar If I make some more crank seal tools, who would want one? Chainsawz 20
Chity_Avatar Home made Stihl PTO side crank seal installer Chainsawz 23
perfoutdoor Dolmar 5105 crank failure Chainsawz 33
H rusted crank is not what i wanted to find Chainsawz 20
trx250r180 10mm 044 crank Wanted 17
Emiles Stihl 048 Clutch side crank oil seal Wanted 13
DefinitiveDave How to separate the bearing from the crank? Chainsawz 12
Virgil 385 Crank Wanted 11
Chity_Avatar 048 crank seals Chainsawz 6
R 295 P&C with Crank Chainsawz 7
jacob j. 385 crank Wanted 1
J 357xp Crank Stuffers Wanted 8
W Pulling Crank Seals Hawgz Garage 38
C who would be the best to get bearings and gaskets for my 066? Chainsawz 14
Black Dog Chainsaw Stihl 044 - where to get good bearings? Chainsawz 17
M KBC Bearings? Chainsawz 2
mdavlee Husky bearings Chainsawz 8
W A question for the been there done that saw builders. About bearings Chainsawz 24