Iowa gtg 350 build saw

[mweba]

Don't want to get to far ahead of muh self but it looks fast already..right?

 

[TK]

Pretty light weight anyway.

 

[mweba]

No port work yet. Just mocking it up tonight. 3mm spacer with two gaskets gets me to .018

Thin ring piston.

Assembled. Riser polishing is sure to shave a tenth off the times

 

[BloodOnTheIce]

Pretty light weight anyway.

saves a couple tenths on the cold starts...

 

[WoodChuck'r]

This just a woodz build Mitch....??

 

[mweba]

This just a woodz build Mitch....??

Umm, well that depends, do I need to revisit the build rules? :tooearly:

It should cut in the woods....I think:notsure:

 

[WoodChuck'r]

lol I just wasn't sure how much you planned on pushing it.....

 

[mweba]

lol I just wasn't sure how much you planned on pushing it.....

Just far enough to win while avoiding emergency room bills

 

[WoodChuck'r]

Sweet. :bananapirate: :dancingpig:

 

[Wigglesworth]

Geeze your freakin slow..... :buttface:

 

[mweba]

Geeze your freakin slow..... :buttface:

Learn from the best buddy

 

[Mastermind]

You could explain what yer building so us cats wit the plastic helmets can keep up. Geeezzzz.....

 

[mweba]

You could explain what yer building so us cats wit the plastic helmets can keep up. Geeezzzz.....

Funny, always pictured you as the tin foil cap type a guy :yup:

Well, this is a 350 with the epa 52cc cylinder(my personal favorite). Slug is a thin ring Mac Titan 50. The pin height is 3mm taller so a buddy machined a riser for me. The plan is to stick with the original intake and carb but we'll see how it runs.

The piston has 29.8mm between the pins so they will be set on the ex side. Trans will be wrapped way back.

"stock"
101
123
71 btdc

 

[Mastermind]

52mm huh? What jug is that?

I do like a good fitting tin hat though. :)

Funny, always pictured you as the tin foil cap type a guy :yup:

Well, this is a 350 with the epa 52cc cylinder(my personal favorite). Slug is a thin ring Mac Titan 50. The pin height is 3mm taller so a buddy machined a riser for me. The plan is to stick with the original intake and carb but we'll see how it runs.

The piston has 29.8mm between the pins so they will be set on the ex side. Trans will be wrapped way back.

"stock"
101
123
71 btdc

 

[mweba]

52cc jeesh. 45mm I believe.

Have a pile of these so I'm gonna try a couple new things. Fingered one already but can't decide if its worth bolting it on.

 

[mweba]

Fingered

 

[Mastermind]

Fingered

Well it looks fast. :bananarope:

 

[Wigglesworth]

Fingered

Poor thing....

Ill see that, and raise you this...

 

[Mastermind]

Poor thing....

Ill see that, and raise you this...

Call......

 

[mweba]

Died it to run the oil out last night. Blowing 195 this morning cold. What ya think running comp is on these thin rings? Ended up indexing the plug whoops