Wigglesworth
autotune gives me a pop-up
I built this saw last summer, and sold it to a friend who hasnt even ran a tank of fuel thru it. He says its time to move it.
This was an extremely low hour 51, that was straight gassed. As nice as it was, I did it up right and split the case and installed new bearings, seals, gaskets, intake tube, impulse grommet and a new intake.
Also installed was a mint 45mm closed port cylinder, with a NOS piston set. These are pistons are now NLA from the dealer. Compression is at 154lbs.
The muffler front has been modded, but it comes with a stock front as well.
Also, will come with a new filter base and filter, its just not got here yet.
It runs great, idles great and oils great.
Looking to get $300 + shipping.
This was an extremely low hour 51, that was straight gassed. As nice as it was, I did it up right and split the case and installed new bearings, seals, gaskets, intake tube, impulse grommet and a new intake.
Also installed was a mint 45mm closed port cylinder, with a NOS piston set. These are pistons are now NLA from the dealer. Compression is at 154lbs.
The muffler front has been modded, but it comes with a stock front as well.
Also, will come with a new filter base and filter, its just not got here yet.
It runs great, idles great and oils great.
Looking to get $300 + shipping.
